Cisco Firepower 2130 Kurulum ve Bakım - Sayfa 22
Sunucu Cisco Firepower 2130 için çevrimiçi göz atın veya pdf Kurulum ve Bakım indirin. Cisco Firepower 2130 26 sayfaları. Rack-mount and ground the chassis
Ayrıca Cisco Firepower 2130 için: Manuel (12 sayfalar), Dağıtım Kılavuzu (8 sayfalar), Başlarken (42 sayfalar)
Sayfayı Yazdır
Install the FIPS Opacity Shield in a Two-Post Rack
Figure 12: TELs Placement on the Chassis
1
TEL 1 on the left side and top of chassis
3
TEL 3 on the top and back of chassis
5
TEL 5 across the FIPS shield and the chassis (towards
the right of the chassis)
TEL 7 on the bottom of the chassis towards the right
7
side of the chassis
Step 8
Attach the power cable to the chassis and connect it to an electrical outlet.
Step 9
Press the power switch on the rear panel.
Step 10
Check the power LED on the front panel. See
indicates that the chassis is powered on.
Step 11
Place the chassis in FIPS mode.
See the following procedures for how to place the chassis in FIPS mode:
•
ASA in Platform Mode
•
ASA in Appliance mode
•
FTD managed by FMC
Installation, Maintenance, and Upgrade
22
2
TEL 2 on the right side and top of chassis
4
TEL 4 across the FIPS shield and the chassis (towards
the left of the chassis)
6
TEL 6 on the bottom of the chassis towards the left
side of the chassis
—
Front Panel LEDs
for a description of the power LED. Solid green
Installation, Maintenance, and Upgrade