Cisco Firepower 2130 Kurulum ve Bakım - Sayfa 21

Sunucu Cisco Firepower 2130 için çevrimiçi göz atın veya pdf Kurulum ve Bakım indirin. Cisco Firepower 2130 26 sayfaları. Rack-mount and ground the chassis
Ayrıca Cisco Firepower 2130 için: Manuel (12 sayfalar), Dağıtım Kılavuzu (8 sayfalar), Başlarken (42 sayfalar)

Sayfayı Yazdır

Installation, Maintenance, and Upgrade

If you are installing the FIPS opacity shield after the initial product installation, the cables are connected.

Note

If the attached cables do not have enough slack to route them through the cable mounting brackets (as

shown in the figure below), you will have to turn the power off on the appliance, remove the cables, route

the cables through the cable mounting brackets, reattach the cables, and continue with Step 5 below.

When you toggle the power switch from ON to OFF, it takes several seconds for the system to power

Note

down. Do not remove the power cable until the power LED is off. After removing power from the chassis

either by moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before

turning power back ON.

Step 4

Route the cables through the openings in the cable management brackets as shown in the figure below.

Step 5

Attach the FIPS opacity shield to the cable management brackets using the four 8-32 x 0.375-inch Phillips screws

provided in the FIPS kit as shown in the figure below.

Figure 11: Route the Cables and Attach the Screws

FIPS opacity shield

Cable management bracket

Step 6

Before you attach the TELs, clean the chassis and FIPS cover of any grease, dirt, or oil with alcohol-based cleaning

pads.

Step 7

Attach the seven TELs. See the figure below for the correct placement. Allow the TELs to cure for a minimum of 12

hours.

Caution

Any deviation in the placement of the TELs means the chassis is not in FIPS mode.

Install the FIPS Opacity Shield in a Two-Post Rack

8-32 x 0.375-inch Phillips screws (two per side)

—

Installation, Maintenance, and Upgrade