Cisco ONS 15454 Kurulum - Sayfa 9

Sunucu Cisco ONS 15454 için çevrimiçi göz atın veya pdf Kurulum indirin. Cisco ONS 15454 32 sayfaları. Four-shelf and zero-shelf bay assembly
Ayrıca Cisco ONS 15454 için: Kurulum Talimatları Kılavuzu (22 sayfalar), Kurulum (32 sayfalar), Paketten Çıkarma ve Kurulum (42 sayfalar), Paketten Çıkarma ve Kurulum (40 sayfalar)

Sayfayı Yazdır

Chapter 1

Install the Shelf and Backplane Cable

NTP-A6 Install the Power and Ground

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Shut off the power from the power source or turn off the breakers before beginning work.

Warning

This equipment is intended to be grounded. Ensure that the host is connected to earth ground during

normal use. Statement 39

Warning

Do not mix conductors of dissimilar metals in a terminal or splicing connector where physical contact

occurs (such as copper and aluminum, or copper and copper-clad aluminum), unless the device is

suited for the purpose and conditions of use.

Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)

Warning

requirements in IEC 60950 based safety standards. Statement 1033

The ONS 15454 relies on the protective devices in the building installation to protect against short

Warning

circuit, overcurrent, and grounding faults. Ensure that the protective devices are properly rated to

protect the system, and that they comply with national and local codes.

March 2005

This procedure installs power feeds and grounds the ONS 15454.

#2 Phillips screwdriver

Medium slot-head screwdriver

Small slot-head screwdriver

Screws

Power cable (from fuse and alarm panel to assembly), #10 AWG, copper

conductors, 194 degrees F [90 degrees C])

Ground cable #6 AWG stranded

Listed pressure terminal connectors such as ring and fork types; connectors

must be suitable for #10 AWG copper conductors

Wire wrapper

Wire cutters

Wire strippers

Crimp tool

Fuse panel

NTP-A4 Remove the Backplane Covers, page 1-7

Required

Onsite

None

NTP-A6 Install the Power and Ground

Cisco ONS 15454 Procedure Guide, R5.0

1-9