Pioneer GM-X962 Kullanıcı El Kitabı - Sayfa 9
Amplifikatör Pioneer GM-X962 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-X962 18 sayfaları. Bridgeable power amplifier
Ayrıca Pioneer GM-X962 için: Kullanıcı El Kitabı (8 sayfalar)
- 1. Before Using this Product
- 2. Composition of Manual
- 3. Setting the Unit
- 4. Connecting the Unit
- 5. Connection Diagram
- 6. Connecting the Power Terminal
- 7. Connecting the Speaker Terminals
- 8. Connecting the Speaker Wires
- 9. Two-Channel Mode (Stereo)
- 10. Component Guide
- 11. Example of Installation on the Floor Mat or on the Chassis
- 12. Specifications
- 13. Average Current Drawn
Connecting the Speaker wires
The speaker output mode can be two-chan-
nel (stereo), one-channel (mono), or three-
channel (stereo + mono). Connect the
speaker leads to suit the mode according to
the figures shown below.
Two-channel mode (stereo)
One-channel mode (mono)
Three-channel mode (stereo + mono)
The power amplifier is basically a two-
channel/one-channel bridgeable amplifier,
but three channels can be achieved by
combining the stereo and mono modes
using inductors and capacitors.
(Right)
Speaker
(Left)
Speaker (Mono)
Three-channel mode, two-way system
Three-channel mode, three-way system
• Inductors (L1 and L2 in the diagrams)
act as low-pass filters. Capacitors (C1
and C2 in the diagrams) act as high-pass
filters. Inductors (L) are used for the
woofer/subwoofer, and capacitors (C)
are used for the high/mid-high.
• Remember when bridging an amplifier it
will see only half of the original speaker
impedance. Therefore, you must use
speakers that have ratings of 4 ohms or
higher. If you use speakers that have
lower impedance ratings it may cause
damage to the amplifier.
• When the inductors and capacitors are
connected to the speaker wires, secure or
solder them so they cannot be pulled
loose. Tape or use heat shrink on the
joints to prevent short circuits.
Mid-high (Right)
C1
Woofer (Mono)
L1
Mid-high (Left)
C1
High/mid-high
C1
(Right)
Mid/mid-bass
L2
C2
(Right)
Woofer/subwoofer
L1
(Mono)
Mid/mid-bass
C2
L2
(Left)
High/mid-high
C1
(Left)