Xerox Synergix 8855 Tamamlayıcı Kılavuz - Sayfa 14

Yazıcı Aksesuarları Xerox Synergix 8855 için çevrimiçi göz atın veya pdf Tamamlayıcı Kılavuz indirin. Xerox Synergix 8855 28 sayfaları. Windows nt 4.0 postscript print driver user guide
Ayrıca Xerox Synergix 8855 için: Kullanıcı Kılavuzu (44 sayfalar), Operatör El Kitabı (11 sayfalar), Tamamlayıcı Kılavuz (26 sayfalar), Yazılım Kılavuzu (30 sayfalar)

Sayfayı Yazdır

XES Synergix 8855 Controller Setup Manual for Firmware 7.0

Front Panel LEDs

The controller has four status LEDs in on the front panel. The functions of

these LED's are as follows:

•

LED1 – Color Green, labeled "Ready" –Indicates the controller is

powered-up and ready to process incoming jobs.

•

LED2 – Color Green, labeled "Busy" –Indicates the controller is busy

processing a job.

•

LED3 – Color Yellow, labeled "Mismatch" –Indicates either a media

mismatch has occurred and is blocking the job queue or a Job

Accounting error has occurred.

•

LED4 – Color Red, named "Attention" –Indicates an printer or finisher

fault occurred, or a paper jam, or out of toner or media, or a

communications problem with one of the devices.

During power-on self-test (POST), the AccXES software turns on LEDs 2,3,

and 4. After POST has successfully completed, LEDs 2,3, and 4 are

extinguished and LED 1 is turned on. If POST did not successfully complete

and the controller is not able to go into "Ready" state, all four LEDs are

extinguished.

LED1

LED2

Figure 4 - Location of LEDs

LED3

LED4