Xerox Synergix 8855 Додатковий посібник - Сторінка 14

Переглянути онлайн або завантажити pdf Додатковий посібник для Аксесуари для принтерів Xerox Synergix 8855. Xerox Synergix 8855 28 сторінок. Windows nt 4.0 postscript print driver user guide
Також для Xerox Synergix 8855: Посібник користувача (44 сторінок), Посібник оператора (11 сторінок), Додатковий посібник (26 сторінок), Посібник з програмного забезпечення (30 сторінок)

XES Synergix 8855 Controller Setup Manual for Firmware 7.0

Front Panel LEDs

The controller has four status LEDs in on the front panel. The functions of

these LED's are as follows:

•

LED1 – Color Green, labeled "Ready" –Indicates the controller is

powered-up and ready to process incoming jobs.

•

LED2 – Color Green, labeled "Busy" –Indicates the controller is busy

processing a job.

•

LED3 – Color Yellow, labeled "Mismatch" –Indicates either a media

mismatch has occurred and is blocking the job queue or a Job

Accounting error has occurred.

•

LED4 – Color Red, named "Attention" –Indicates an printer or finisher

fault occurred, or a paper jam, or out of toner or media, or a

communications problem with one of the devices.

During power-on self-test (POST), the AccXES software turns on LEDs 2,3,

and 4. After POST has successfully completed, LEDs 2,3, and 4 are

extinguished and LED 1 is turned on. If POST did not successfully complete

and the controller is not able to go into "Ready" state, all four LEDs are

extinguished.

LED1

LED2

Figure 4 - Location of LEDs

LED3

LED4