Alemite 8568-MA Servis Kılavuzu - Sayfa 7
Su Pompası Alemite 8568-MA için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Alemite 8568-MA 10 sayfaları. Medium-pressure stub pump
Sayfayı Yazdır
Medium-Pressure Stub Pump
IMPORTANT: Do not mix Springs. Make sure to use
the light-duty spring from the kit. The heavy-duty
spring will not operate in pump model 8568.
3. Install Spring (11) into the Piston Adapter.
• Make sure the Spring centers on the Ball.
Refer to Figure 2 Parts List
for Parts Identification
Figure 5 Pump Tube 321314 - Section View
Alemite, LLC
4. Screw Coupling Rod (8) into the Piston
Adapter until the pin holes are in alignment.
5. Press on the Ball to ensure it operates and seats
properly.
• Use a small screwdriver or other suitable
tool.
Support the Rod Coupling and the Piston
Adapter during Roll Pin installation. Dam-
age to components can occur.
6. Install Roll Pin (10) to secure the Coupling
Rod to the Piston Adapter.
• Use a small hammer.
7. Install Wear Rings (13), O-Ring (15) and
Back-Up Washer (16) onto the Piston.
8. Install O-Ring (6) onto Valve Seat (21).
9. Install O-Ring (4) and O-Ring (6) onto the
Tube Adapter.
• Make sure to place the larger O-Ring on the
upper portion of the Adapter (with holes).
10. Install Bung Adapter (18) onto Tube and Guide
assembly (17).
• Tighten the Bung Adapter bolt.
11. Install Spring (19) and Valve Disk (20) into the
bottom of the Tube and Guide assembly.
• Make sure the components are stacked and
centered properly.
12. Screw the Valve Seat into the Tube and Guide
assembly. Use care when passing over the
O-Ring.
• Use the Bung Adapter as a lever and tighten
securely.
13. Turn the Tube and Guide assembly end for
end.
Use care not to damage the piston rings
during the installation process.
14. With a slight twisting motion, install the piston
assembly into the Tube and Guide assembly.
• Ease the lubricated assembly past the tube
threads.
7
SER 8568-A4
CAUTION
CAUTION
Revision (7-05)