3D Creations North American P 51 D Mustang Montaj Talimatları Kılavuzu - Sayfa 2

Oyuncak 3D Creations North American P 51 D Mustang için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. 3D Creations North American P 51 D Mustang 15 sayfaları. Paper scale model kit

Sayfayı Yazdır

3D Creations North American P 51 D Mustang Montaj Talimatları Kılavuzu

Now for your first part assembly

that requires a forming of the pieces

to be joined. First place part #6 in it's

correct place (Directly behind #7

overlapping it slightly). Pay careful

attention to its placement using the

printed panel lines and color to help

you line it up. As the piece is

attached you

must draw the

sides of the

fuselage into piece #6 making sure #6 and #7 stay lined up. If done

correctly the top of the nose section should have a slight cup shape to

it. At this point you must curl the nose section to its desired shape

before you can attach any other pieces. What needs to be done is to

roll part #7 an #6

creasing it

fuselage sides flat. This allows

you to mount the following pieces without wrinkling

them. See figure 3. It will naturally snap back some

from this position which is OK. You're just

establishing the shape right now.

Now it is time to bend the light blue tabs at the rear

of the fuselage. See figure 4. This will become the

rudder mounting area later in the construction. These

blue tabs are to be bent inward at a right angle to the fuselage. First make a small cut

along the front edge of the tab down to the white line. This helps

Fuselage Assembly

Cut out parts #1, #2, #3,and #4. Glue the wing mount

sections (parts #3 & #4) to the fuselage parts #1 & #2

matching up the paint scheme to insure that they are

mounted on the correct side. Next cut out parts #6, #7, and

#24. Glue part #7 to part #2 as shown in figure 1. Now glue

part #1 to the other side of part #7 in the same way.

See figure 2.

without

while leaving the

make a clean fold.

Score and crease

along the white line

at the bottom of the

tab and fold. Now

draw the two blue

tabs together and

glue one tab exactly

on top of the other.

You will need to