3D Systems CubePro Orijinal Talimat Kılavuzu - Sayfa 10

3D Yazıcılar 3D Systems CubePro için çevrimiçi göz atın veya pdf Orijinal Talimat Kılavuzu indirin. 3D Systems CubePro 12 sayfaları. Unjamming extruder
Ayrıca 3D Systems CubePro için: Orijinal Talimat Kılavuzu (18 sayfalar), Manuel (11 sayfalar)

3D Systems CubePro Orijinal Talimat Kılavuzu
10. Using a 2 mm hex driver, loosen and remove the four (4) screws
securing the power supply to the standoff pems and remove the power
supply.
NOTE: The screws will be reused for reassembly.
11. Place the new power supply over the standoffs and insert the original
screws.
CAUTION: EXERCISE CAUTION WHEN WORKING AROUND
CIRCUIT BOARDS. COMPONENTS ARE EASILY DAMAGED
AND ANY DAMAGE MAY VOID YOUR MANUFACTURER'S
WARRANTY.
12. Using the 2 mm hex driver, carefully tighten the screws to secure the
power supply.
CAUTION: DAMAGE TO THE POWER SUPPLY CAN OCCUR
IF THE SCREWS ARE OVER-TIGHTENED. EXERCISE
CAUTION WHEN TIGHTENING THE SCREWS.
13. Carefully connect the blade connector (A) and the two (2) wire
connector to the back of the power supply.
NOTE: Depending on your printer model, some junctions may
not be used. Refer to your notes and the connections diagram
on page 4. If you need further assistance, contact support.
3D Systems, Inc.
9
B
A