3D Systems CubePro Manual Petunjuk Asli - Halaman 10

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 12 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual Petunjuk Asli (18 halaman), Manual (11 halaman)

Halaman Cetak

10. Using a 2 mm hex driver, loosen and remove the four (4) screws

securing the power supply to the standoff pems and remove the power

supply.

NOTE: The screws will be reused for reassembly.

11. Place the new power supply over the standoffs and insert the original

screws.

CAUTION: EXERCISE CAUTION WHEN WORKING AROUND

CIRCUIT BOARDS. COMPONENTS ARE EASILY DAMAGED

AND ANY DAMAGE MAY VOID YOUR MANUFACTURER'S

WARRANTY.

12. Using the 2 mm hex driver, carefully tighten the screws to secure the

power supply.

CAUTION: DAMAGE TO THE POWER SUPPLY CAN OCCUR

IF THE SCREWS ARE OVER-TIGHTENED. EXERCISE

CAUTION WHEN TIGHTENING THE SCREWS.

13. Carefully connect the blade connector (A) and the two (2) wire

connector to the back of the power supply.

NOTE: Depending on your printer model, some junctions may

not be used. Refer to your notes and the connections diagram

on page 4. If you need further assistance, contact support.

3D Systems, Inc.