3D Systems CubePro Manual Petunjuk Asli - Halaman 9

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Printer 3D 3D Systems CubePro. 3D Systems CubePro 12 halaman. Unjamming extruder
Juga untuk 3D Systems CubePro: Manual Petunjuk Asli (18 halaman), Manual (11 halaman)

3D Systems CubePro Manual Petunjuk Asli
6.
Lift the front edge of the floor and secure it through the slot to the front
chassis crossbar with a zip tie.
7.
Using a 3 mm hex driver, loosen and remove all four (4) screws
securing the power supply cover to the inner floor and remove the cover.
8.
Using a Phillips screwdriver, loosen and remove both (2) Phillips screws
securing the wire connectors to the positive and negative terminals.
Retain the screws for reinstallation.
NOTE: Make note of each connection so they will be
reconnected properly during reassembly.
9.
Remove the 401883 blade connector (A) from the blade terminal.
Carefully disconnect 401882 (B), the two (2) pin connector, from the
power supply.
3D Systems, Inc.
8
B
A