3D Systems CubePro 원본 사용 설명서 - 페이지 9

{카테고리_이름} 3D Systems CubePro에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems CubePro 12 페이지. Unjamming extruder
3D Systems CubePro에 대해서도 마찬가지입니다: 원본 사용 설명서 (18 페이지), 매뉴얼 (11 페이지)

페이지 인쇄

Lift the front edge of the floor and secure it through the slot to the front

chassis crossbar with a zip tie.

Using a 3 mm hex driver, loosen and remove all four (4) screws

securing the power supply cover to the inner floor and remove the cover.

Using a Phillips screwdriver, loosen and remove both (2) Phillips screws

securing the wire connectors to the positive and negative terminals.

Retain the screws for reinstallation.

NOTE: Make note of each connection so they will be

reconnected properly during reassembly.

Remove the 401883 blade connector (A) from the blade terminal.

Carefully disconnect 401882 (B), the two (2) pin connector, from the

power supply.

3D Systems, Inc.