3D Systems CubePro Оригинальное руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для 3D-принтеры 3D Systems CubePro. 3D Systems CubePro 12 страниц. Unjamming extruder
Также для 3D Systems CubePro: Оригинальное руководство по эксплуатации (18 страниц), Руководство (11 страниц)

3D Systems CubePro Оригинальное руководство по эксплуатации
6.
Lift the front edge of the floor and secure it through the slot to the front
chassis crossbar with a zip tie.
7.
Using a 3 mm hex driver, loosen and remove all four (4) screws
securing the power supply cover to the inner floor and remove the cover.
8.
Using a Phillips screwdriver, loosen and remove both (2) Phillips screws
securing the wire connectors to the positive and negative terminals.
Retain the screws for reinstallation.
NOTE: Make note of each connection so they will be
reconnected properly during reassembly.
9.
Remove the 401883 blade connector (A) from the blade terminal.
Carefully disconnect 401882 (B), the two (2) pin connector, from the
power supply.
3D Systems, Inc.
8
B
A