- ページ 9

3Dプリンター 3D Systems CubeProのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。3D Systems CubePro 12 ページ。 Unjamming extruder
3D Systems CubePro にも：オリジナル取扱説明書 (18 ページ), マニュアル (11 ページ)

ページを印刷する

Lift the front edge of the floor and secure it through the slot to the front

chassis crossbar with a zip tie.

Using a 3 mm hex driver, loosen and remove all four (4) screws

securing the power supply cover to the inner floor and remove the cover.

Using a Phillips screwdriver, loosen and remove both (2) Phillips screws

securing the wire connectors to the positive and negative terminals.

Retain the screws for reinstallation.

NOTE: Make note of each connection so they will be

reconnected properly during reassembly.

Remove the 401883 blade connector (A) from the blade terminal.

Carefully disconnect 401882 (B), the two (2) pin connector, from the

power supply.

3D Systems, Inc.