- ページ 11

3Dプリンター 3D Systems CubeProのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。3D Systems CubePro 12 ページ。 Unjamming extruder
3D Systems CubePro にも：オリジナル取扱説明書 (18 ページ), マニュアル (11 ページ)

ページを印刷する

14. Using a Phillips screwdriver, reconnect the wire connectors to both

the positive terminal and negative terminal using the original two (2)

screws.

15. Reinstall the power supply cover. Insert the original four (4) 3 mm hex

head screws through the cover and into the inner floor and secure

them.

NOTE: To prevent damaging the wires, ensure the wires are

routed under the wire openings on the front and back of the

cover.

16. While supporting the floor, carefully remove the wire tie.

17. Lower the inner floor and align the screw holes with the standoffs

underneath.

18. Insert the original nine (9) screws that were removed in step 5 and

secure them using a 3 mm hex driver.

19. Connect the power cord to the printer and turn on the main power

switch. Press the on/off button to turn on the display.

3D Systems, Inc.