3D Systems Touch Kullanıcı Kılavuzu - Sayfa 11

Tıbbi Ekipman 3D Systems Touch için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3D Systems Touch 19 sayfaları. 3d stylus hands on design
Ayrıca 3D Systems Touch için: Kullanıcı Kılavuzu (17 sayfalar)

Sayfayı Yazdır

GETTING TO KNOW THE TOUCH

TOUCH COMPONENTS

The picture below labels the parts of the Touch device.

USB Connection

LED (LIGHT) RING INDICATORS

The LED ring at the base of the Touch will display a different color light depending on the status of the Touch.

•

Blue - Power is on, but not communicating with application

- Displays blue after the power supply is plugged in

- Displays blue if GTDD (Geomagic Touch Device Driver) is not installed

- Displays blue if Geomagic Touch Setup utility has not been run

- Displays blue when no haptic enabled application is open

•

Blinking Blue - Communicating with application, Touch needs to be calibrated

- Displays blinking blue when the Touch needs to be calibrated by placing the stylus pen in the inkwell

- Displays blinking blue when the Touch needs to be calibrated by opening the Geomagic Touch Diagnostic utility and calibrating

White - In inkwell for calibration, communicating with application, Force feedback inactive

•

- Displays white when the stylus is in the inkwell during and after calibration. The Touch is communicating with the open

application, but force feedback is not being used.

•

Green - Calibrated, communicating with application, Force feedback is active

- Displays green when the Touch is calibrated and is communicating with an open application. The Touch is using force feedback.

NOTE: The orb stylus will always display white.

3D Systems, Inc.

LED ring indicator

Elbow

Arm

Orb

Inkwell

Stylus