3DHS SLICK 580 Montaj Kılavuzu - Sayfa 9

Oyuncak 3DHS SLICK 580 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 3DHS SLICK 580 16 sayfaları.

9. Install the landing gear cover using Goop silicone glue or thick CA.

10. Locate the horizontal stabilizer/elevator assembly and slide the elevator

off of the hinges. Turn the elevator over so that the counter balances face the

rear of the aircraft and insert the elevator into the slot in the rear of the

fuselage. Rotate the elevator into proper position and then slide the

horizontal stabilizer into position.

11. Insert the carbon fiber wing tube into the sleeve in the fuselage. Use a

ruler to insure that the stabilizer is centered in its slot and compare the

stabilizer to the wing tube to make sure it is properly aligned. Sand or shim

the slot if necessary to ensure proper alignment. Secure the stabilizer with

CA. Slide the elevator onto the hinges and secure with thin CA.