Artico SY-AC900 Kullanıcı Kılavuzu - Sayfa 9

Klima Artico SY-AC900 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Artico SY-AC900 13 sayfaları.
Ayrıca Artico SY-AC900 için: Kullanıcı Kılavuzu (16 sayfalar)

Sayfayı Yazdır

•

As shown on the picture below, remove the plug of the drainage cap, the aqueduct

and place the other end of the aqueduct into the water container or drain

channel.

•

When entering dehumidification mode, if the room temperature ≥17 ºC (62 ºF),

the compressor will start to work. When the room temperature

≤15 ºC (59 ºF), the compressor stops. When the temperatures raises back to

≥17 ºC, the compressor restarts again.

(in order to protect the compressor, it will be restarted 3min. later).

•

In dehumidification mode, the speed of the fan is by default at Low speed and

the wind speed is not adjustable.

•

Temperature cannot be set.

Note: when using the dehumidify function, you should remove the exit pipe

components, or else this function will fail to perform and the error message of "FL"

will appear indicating that the water level is full.

Timer mode

•

In standby mode, press the timer button to set ON time. Press the Up and Down

buttons to set the starting time (1~24H), the timer indicator lamp lights on.

•

In Startup mode, press the timer button to set OFF time. Press the Up and Down

buttons to set the switch off time (1~24H), the timer indicator lamp lights on.

Important Note:

•

Never turn off the air conditioner by unplugging it from the power supply. Always press the

"ON / OFF" button and wait a few minutes before unplugging it. This allows the device to perform

a check cycle to verify operation.

Water Drainage

The product has an automatic water evaporation system. The circulation of condensed water, cools

down the condenser. This not only increases refrigeration efficiency but also saves energy.

•

When the water tank is full, the LCD display indicates "FL" and

the compressor stops working automatically. At this point:

1. Turn the unit off and unplug the power cord.

2. Remove the exhaust duct assembly.

3. Move the unit to an appropriate place.

4. Unscrew the water drainage cover and unplug the water blocker.

Use a water container to remove the water from under the unit.

5. Plug in the water drainage cover well.

6. Reinstall the exhaust duct assembly and start the machine.