Ashly MQX-2310 Kullanım Kılavuzu - Sayfa 6

Kayıt Ekipmanları Ashly MQX-2310 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Ashly MQX-2310 13 sayfaları. Graphic equalizer
Ayrıca Ashly MQX-2310 için: Broşür (1 sayfalar), Kullanım Kılavuzu (16 sayfalar), Kullanım Kılavuzu (12 sayfalar), Teknik Notlar & Özellikler (2 sayfalar)

Sayfayı Yazdır

Page - 6

Introduction - 4

Physical Description

MQX Equalizers – 5

The MQX-2310 is 2RU, and weighs 11 pounds.

Connectors & Cables – 5

Physical Description - 6

Front Panel

Rear Panel

Installation – 7

Typical Applications - 8

Troubleshooting - 9

Dimensions - 9

Specifications - 10

Warranty - 11

MQX-2310 Front Panel

Power LED – Displays power on or off.

Equalization - The individual equalization

faders adjust the gain or loss at each filter

frequency. There are 31 of these faders per

channel on the MQX-2310. By adjusting a

combination of faders, an overall frequency

response can be developed and the physical

position of the faders will give an approximate

visual indication of this response.

Gain - The gain control adjusts the overall gain

of the equalizer when the EQ switch is "in". It is

generally used to compensate for level

changes due to the equalization process, but

can also adjust overall system level and gain

structure. Overall gain with this control is from

+6dB to -∞.

Signal Present LED – A green LED indicates

when input signal to the equalizer is above

–20dBu. EQ or Gain settings have no effect on

this indicator, as it only tells you the level of

signal applied to the equalizer.

Clip Indicator LED – The red Clip LED turns

on when any signal within the audio path

MQX-2310 Rear Panel

Power – Switches the unit power on or off

Inputs - For unbalanced inputs, the signal

should be on the + connection and the -

connection tied to ground. A mono 1/4" plug

used as an unbalanced connection will

automatically be grounded. When using a

stereo plug, XLR connector, or euroblock for an

unbalanced signal, the (-) input connection

MUST be tied to ground.

Operator Manual – MQX-2310 Equalizer

exceeds +19dBu. Clipping can be detected at

the input stage, gain stage, or equalizer output.

Range Switch - This switch selects the

operating range of the individual equalization

faders between 15dB and 6dB. The 15dB

settings should be used when this much

equalization is needed. The 6dB setting allows

finer resolution on the fader settings.

EQ In/Out Switch - This switches the Graphic

Equalization and gain adjustments, allowing the

effect of any equalization to be compared to a

"flat" response. This switch does not defeat the

High-pass filter.

High-Pass Filter - The high-pass filter can be

used to supplement the frequency response

achieved by the bandpass filters. Its function is

to "roll off" the response below a given

frequency eliminating subsonic interference like

wind noise or floor rumble. The high-pass

frequency is fixed at 40Hz with an 18dB/Oct

slope.

Ashly Servo-Balanced Output - This output

circuit is an active output which maintains a

constant output level between the (+) and (-)

output terminals, regardless of either terminal

being connected to ground. This servo-

balanced output provides an unchanged signal

without regard to ground.