Canon CanoScan 9000F Посібник із швидкого старту - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Сканер Canon CanoScan 9000F. Canon CanoScan 9000F 19 сторінок. Brochure
Також для Canon CanoScan 9000F: Брошура (8 сторінок), Посібник із швидкого старту (39 сторінок)
Друкувати сторінку
- 1. Table of Contents
- 2. Safety Precautions
- 2. General Handling Precautions
- 2. Setup and Operating Conditions
- 3. Package Contents
- 4. Installing the Software
- 5. Preparing the Scanner
- 6. Connecting the Scanner
- 7. Try Scanning
- 8. Using the Scanner Buttons
- 9. Scanning with MP Navigator EX
- 10. Scanning Film
- 11. Specifications
35 mm Slides
Align the Film Guide's tab with the FILM
symbol on the platen glass of the scanner.
Place a slide or slides face down (correctly
viewed from below) in the Film Guide as
shown in the figure on the right.
120 Format Films
Align the Film Guide's tab with the FILM
symbol on the platen glass of the scanner,
then open the Film Holder and remove the
Film Retainer Sheet.
Place the film face down.
Close the Film Holder.
• Leave a gap of 5 mm
between films when placing two or more
120 format films on the platen glass.
• Ensure that there is no gap between the
edge of the film and the Film Guide on the
side near the Calibration Slot.
(0.2 in.)
or greater
Scanning Film
Calibration Slot
Calibration Slot
13