Baumer O200 Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Аксесуари Baumer O200. Baumer O200 34 сторінки. Sensors with io-link
Друкувати сторінку
Switch Counts
4.2.2
For each individual SSC a switching counter is implemented, which can be used as diagnosis data or also as
measurement value. The number of counts of each channel can also be mapped to the measurement data
channel MDC by adjusting the MDC source. Trigger of counter is on positive slope of related SSC.
Note:
Each power up, the switch counts are being reset/start from 0.
Parameter name
-
SSC1 Switch Counts
Reset
-
SSC4 Switch Counts
Reset
-
Switch Counts.SSC1
Resetable
-
Switch Counts.SSC4
Resetable
MDC Source
4.2.3
Selects which measuring value is mapped to the MDC channel and is then available via the process data-IN
path. When SSC1, SSC2 or SSC4 is selected the number of switches detected by the channel is shown.
Parameter name
MDC Selection.Source
MDC Descriptor
4.2.4
This parameter allows to read out the limits of the measuring range of the sensor and unit. When the sensor
detects values outside of this range, it will report an out of range value (32760).
Parameter name
MDC Descriptor.Unit
Code
MDC
Descriptor.Lower Limit
MDC
Descriptor.Upper Limit
en_BA_O200_IO-Link_V1.docx
15.08.2018/
Short Description
Command to set the counter value of SSCn to
zero.
Available for SSC1 and 4.
Number of switching operations.
Available for SSC1 and 4.
Short Description
Defines the measuring value which is
mapped to the MDC channel for
availability via the process data-IN
path.
Short Description
Shows the unit of the selected MDC source
lower limit of the measuring range
upper limit of the measuring range
Rights
ro
10/34
Rights
Unit / Allowed
values
32 Bit value
wo
32 Bit value
ro
Unit / Allowed values
-
Intensity (Only O200.R)
-
Quality Value
-
Switch Counter SSC1
-
Switch Counter SSC4
Rights
Unit / Allowed
values
ro
ro
ro
Baumer Electric AG
Frauenfeld, Switzerland