DPR Hyper Cub Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка DPR Hyper Cub. DPR Hyper Cub 4 сторінки. Limited edition rc version

Connect the Z-bends to the

servo horns and position in the

centre position as shown.

At the other end of the rod, position the control horns so the

connection point is over the control surface hinge point. You will

need to make a slit in the wood for the control horn to be inserted

Before gluing in place terminate the push rod with another

Z bend and connect to the horn, then glue horn in place ensuring

the control surface and servo`s are all at the neutral position.

Use the V bend if there is slight trimming needed.

Now the installation is complete you need to check the C.O.G.

The battery needs to be put in place and the C.O.G needs to be

as shown in the image, which is about 38mm from the leading

edge.

38mm

Recommended control movement

Elevator UP / DOWN

5MM - 15MM

EXPO 10% - 25%

Rudder LEFT / RIGHT 10MM - 15MM

EXPO 10% - 25%

Please always remember to do a range check before your ﬁrst ﬂight and always ﬂy safe.

Distributed by

J Perkins Distribution

Northdown Business Park, Lenham, Kent, ME17 2DL