Dremel DigiLab 3D45 Інструкція з обслуговування - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з обслуговування для 3D-принтери Dremel DigiLab 3D45. Dremel DigiLab 3D45 4 сторінки. Print removal
Також для Dremel DigiLab 3D45: Посібник із швидкого старту (2 сторінок), Інструкція з експлуатації (2 сторінок), Посібник (4 сторінок), Посібник з експлуатації (4 сторінок), Посібник з калібрування (2 сторінок), Посібник із швидкого старту (2 сторінок)

b. Remove screw located on the right side hole using the

T10 Torx screwdriver. Figure 4a below shows the location

of the screw, and Figure 4b shows a bottom view of the

area where the screw is located. Circled in red, is the

screw that needs to be removed.

Figure 4a (Left) and 4b (Right): Remove screw located on

the right side on the bottom of extruder.

c. Unscrew the two screws on the top of the filament guide

bracket using the 2.5mm Hex wrench.

Figure 5: Extruder cover removal.

d. Remove the top cover.

e. Carefully unplug filament run out switch from the extruder

circuit board, ensuring to pull from the plastic plug and not

the wires; pulling the wires can damage the connection to

the extruder.

Figure 6: Runout switch being disconnected

from extruder PCBA

Step 3: Remove Shielded Circuit Cable

a. Using the 2 black push pins (encircled red) of the shielded

b. Remove the connector from the circuit board and pull up

c. Set aside the cable within the machine, making sure there

Step 4: Remove the Leveling Servo Assembly

a. Remove the three screws holding the servo motor bracket

circuit ribbon cable, push down to release it from the cir-

cuit board.

Figure 7a. 7b: Disconnect shielded circuit ribbon

cable from extruder PCBA.

on the cable. Always use great care when handling a

shielded circuit cable.

Figure 8: Removal of ribbon cable from extruder housing.

are no sharp kinks or turns produced.

in place with a T10 Torx (star) bit.

Figure 9: Unscrew servo motor levelling switch chassis.