Danfoss FP975 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Терморегулятор Danfoss FP975. Danfoss FP975 16 сторінок. 7 day electronic programmer with separate outputs for heating & hot water, which can be set at independent times.
Також для Danfoss FP975: Посібник з монтажу (16 сторінок), Інструкція користувача (2 сторінок)

Друкувати сторінку

Please Note

The unit must be programmed in sequence and ON/OFF times

cannot be set out of sequence.

If you want to leave a preset time as it is, simply press NEXT ON/

OFF to move on to the next setting.

Your timeswitch allows you to programme 3 ON and 3 OFF times

each day. If you do not wish to use one of the ON/OFF settings,

simply programme the ON time to be the same as the OFF time

and the setting will not operate.

If at any time you get confused and need to reset your timings

to the standard programme, press the RESET button to return

to the preset programmes (see page 7).

1.7.1 Programming the heating in 5/2 day mode

Press PROG until SET CH ON

TIME appears at the top of the

display and MOTUWETHFR

appears at the bottom of the

display.

Use the + and - buttons to set

the time you would like your

heating to ﬁ rst come on in the

morning (Event 1).

Press NEXT ON/OFF once only.

Use the + and - buttons to set

the time you want your heating

to go oﬀ (Event 2).

To move to the next setting,

i.e. when you would like your

heating to come on again

(Event 3) press the NEXT ON/

OFF button again.

Danfoss Heating