Danfoss FP975 사용자 설명서 - 페이지 9

{카테고리_이름} Danfoss FP975에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss FP975 16 페이지. 7 day electronic programmer with separate outputs for heating & hot water, which can be set at independent times.
Danfoss FP975에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 사용자 지침 (2 페이지)

페이지 인쇄

Please Note

The unit must be programmed in sequence and ON/OFF times

cannot be set out of sequence.

If you want to leave a preset time as it is, simply press NEXT ON/

OFF to move on to the next setting.

Your timeswitch allows you to programme 3 ON and 3 OFF times

each day. If you do not wish to use one of the ON/OFF settings,

simply programme the ON time to be the same as the OFF time

and the setting will not operate.

If at any time you get confused and need to reset your timings

to the standard programme, press the RESET button to return

to the preset programmes (see page 7).

1.7.1 Programming the heating in 5/2 day mode

Press PROG until SET CH ON

TIME appears at the top of the

display and MOTUWETHFR

appears at the bottom of the

display.

Use the + and - buttons to set

the time you would like your

heating to ﬁ rst come on in the

morning (Event 1).

Press NEXT ON/OFF once only.

Use the + and - buttons to set

the time you want your heating

to go oﬀ (Event 2).

To move to the next setting,

i.e. when you would like your

heating to come on again

(Event 3) press the NEXT ON/

OFF button again.

Danfoss Heating