Gadhouse HENRY Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Вертушка Gadhouse HENRY. Gadhouse HENRY 13 сторінок.
7. Gently pull up the tonearm from its rest and move it over the record
where play is desired to begin. Use the Tonearm Lift Lever to raise the
Tonearm Lift and let the tonearm sit on it.
8. Set the Tonearm Lift Lever back to the down position, the tonearm will
descend slowly onto the record and begin playback.
9. When the record is finished playing, use the Tonearm Lift Lever to raise
the tonearm and then return it to the tonearm rest. To suspend the
playback, repeat the same steps.
10. Press the PLAY / STOP button again, the platter stop turning.
Bluetooth Receiver Function (BT)
1. Press the Power Switch to turn on the power.
2. Press the MODE button to choose Bluetooth mode, the indicator will
light in blue. You will hear an activation sound from the unit.
Turn on the Bluetooth feature of your audio device, search for
and pair.
Once your device is successfully paired with the unit, you will hear a short
confirmation sound "Connected" Play and stream music from your device
to the unit.
Enjoy the music!
OUTPUT
Stereo System Output
RCA Jacks
The RCA Jacks of this unit are shared as both the Phone output jacks and
the Line output jacks. They are determined by the Phono/Line Switch.
When used as a line output, the jacks output analog line-level signals and
could be connected directly with a pair of active speakers or the appropri-
ate input of your stereo system. When used as a Phono output, they should
be connected to the phono pre-amplifier or the phono input of the stereo
system.
"HENRY"
16
NOTE:
If the Phono/Line switch is set at LINE position but RCA jacks connected
to the stereo system's phono input, the sound might be distorted due to
input overload and could damage your stereo system.
If the Phono/Line switch is set at PHONO position but RCA jacks
connected to the stereo system's line input, the volume will be very low
due to lacking signal pre-amplification.
RCA Jack is not designed to be connected directly to the passive/unpow-
ered speakers and if it does, the volume will be very low.
UPC-Encoding
Visit our tutorial page to see the instruction of both macOS/Windows
operating system
www.gadhouse.com/tutorial or QR code below;
17