GREAT PLAINS Yield-Pro 3P4025AH Посібник з польових налаштувань - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з польових налаштувань для Сільськогосподарське обладнання GREAT PLAINS Yield-Pro 3P4025AH. GREAT PLAINS Yield-Pro 3P4025AH 6 сторінок. 3-point stack-fold air-pro planter
Також для GREAT PLAINS Yield-Pro 3P4025AH: Інструкція з монтажу Посібник з монтажу (7 сторінок)

Друкувати сторінку

Ground Drive Adjustments:

When planting, if the monitor indicates under seeding, check the

ground drive to see if it is slipping and adjust as necessary.

1) Raise the planter so that the gauge wheels are just off the

ground.

2) Loose the top nut (12) just above the yoke block.

3) Using an open-ended or adjustable wrench at the integral hex

nut (13), rotate the link to adjust the gauge wheel tension. Using

the base of the link flange, and the pivot grease zerk (14) as ref-

erence points, increase the distance to increase the down-force

on the gauge wheel.

4) Once the desired tension is achieved, re-tighten the top nut

(12).

Adjusting Down Pressure:

1) Use a 1 1/8 inch open-ended wrench or the provided tool

stored on the planter. Position the wrench on the adjusting nut

and pull back and down on the wrench to adjust the cam to a

new setting.

Note: Do not set all rows higher than notch 4 as using this set-

ting on all rows will create an uneven depth control and improper

function.

2) Minimum and maximum settings are indicated by the position

of the adjusting cam. Each notch on the adjusting cam will

increase or decrease the down pressure.

Adjusting Hydraulic Down Pressure:

1) Individually set each row unit to have a mechanical down

pressure setting on 3.

2) Set the tractor's hydraulic lever to constant flow to provide

constant pressure to the down-pressure cylinders. Release the

locking disk (15) and turn the knob (16) on the pressure control

valve.

3) While turning the adjustment knob, observe the pressure

gauge (17) and set the desired pressure. Adjusting the knob

clockwise will increase the down pressure while adjusting the

knob counterclockwise will decrease the overall down pressure.

Note: The recommended pressure range for the planter is

between 400 psi and 600 psi.

Adjusting Disc Contact:

1) Completely raise the planter and install the transport locks

onto the lift-assist cylinders.

2) Remove the side gauge wheels on the row unit to be

adjusted.

3) Remove the bolt (18) retaining the opener disc to the row unit.

Carefully remove the disc (19), noting how many spacers (20)

are outside the disc and inside the disc.

hub components and spacers.

4) To reduce the spacing between the disc, move one spacer

from the inside to the outside of the disc.

5) Re-assemble and check the disc contact for further adjust-

ments.

Document

#PLUS300C-0002A

Note: Do not lose the

4 of 6

48927

Maximum

Setting

Minimum

Setting

27065

48928

48388