Maintronic Sx2 Tuning-Dongle Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари для велосипедів Maintronic Sx2 Tuning-Dongle. Maintronic Sx2 Tuning-Dongle 5 сторінок. For ebike; with bosch active / bosch performace line cablekit sx2kb-perf

Друкувати сторінку

Scope of delivery

•

1x cablekit Bosch Active / Performance Line with

3,5mm stereo jack socket (5)

•

2x gel insulated blade connectors (2)

•

1x Sx2 Tuning-Dongle (6),

•

1x user manual Sx2 Tuning-Dongle with Bosch

Classic Line cablekit

Image label Bosch Active/Performance Cablekit

black

red

black

green

yellow

+5V

Sx2

switching time of the speed sensor. The shorter the

switching time, the sooner is the switchoverpoint and

conversely. Try to turn up the pedal by hand while the

engine is turned off till 50km/h and watch the speedo-

Installation Bosch

The best solution is to connect the cablekit directly be-

hind the speedsensor plug inside of the engine termi-

nal.

It is located behind the stone chip cover of the engi-

ne which is screwed on with 3 Torx screws. At first the

crank crank has to be removed. For this reason the fol-

lowing special tools are required: 8mm 5-hex key to un-

lock the crank screw, Isis crank puller for dismounting

the crank. And a Torx T20 key for the chip cover screws.

red

Once the crank and the protective cover are removed

you get access to the speedsensor plug(1). The next

step is to unplug the speed sensor plug (1) from the en-

gine carefully.

orange

Connect the Sx2 Tuning-Dongle parallel to the speed-

sensor. Please take care of the polarity. Red to red (3)

and black to black (4). The orange wire (5) is connected

to the red wire which leads to the + wire of the control

unit Intuvia (6).

- Ground

Is an extension of the connection cable possible?

ANSWER:

Yes, with a commercial standard headphone extension

cord, the Sx2 Tuning-Dongle can be placed anywhere on

Creation date:

For connecting the wires with the blade connectors

insert each wire (without stripping) of the Sx2 Tuning-

Dongle cable into the one-sided openings of the blade

connectors (2).

The related wires of the speedsensor and the + wire

of the control unit Intuvia (6) are inserted into the

through-opening of the blade connectors. Now press

down with your hand the blade connectors (2) firmly.

Compress with a pliers as possible parallel.

01 / 2014