Gamma 5003 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Нанизувальні машини Gamma 5003. Gamma 5003 19 сторінок. 6 point mounting
Також для Gamma 5003: Посібник користувача (20 сторінок), Посібник користувача (20 сторінок), Посібник користувача (20 сторінок)

ASSEMBLY INSTRUCTIONS

Base Leg Assembly

The GAMMA 5003 stringing machine uses a four leg

base design. The legs must be assembled to the support

post before use. Remove the lower column support from

the carton. This is the larger of the two posts and has the

GAMMA label.

Note: For illustration purposes, the support column has

been painted white for these instructions.

Align the holes in the leg flange with the matching holes

in the lower column support post. Secure the leg with one

FLAT HEAD cap screw through the upper hole, and one

SOCKET HEAD cap screw through the bottom hole.

Repeat this procedure for the three remaining legs.

Base Foot Height Adjustment

Each foot of the GAMMA 5003 Base Stand can be ad-

justed to compensate for uneven surfaces.

Upper Column Support Assembly

Insert the upper column support into the lower column

support / base leg assembly. Leave the upper column

extended to maximum height and lock in place with the

two set screws located at the top of the lower column

support.