IKEA 302-371-38 Посібник - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник для Варильна поверхня IKEA 302-371-38. IKEA 302-371-38 44 сторінки.
Також для IKEA 302-371-38: Посібник (44 сторінок)
Друкувати сторінку
ENGLISH
Problem
The residual heat indicator is
not displaying anything.
There is no signal when you
touch the panel sensor fields.
lights up on the heat set-
ting display.
symbol plus a number
appears on the heat setting
display.
lights up on the heat
setting display.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact
your dealer or the After Sales Service.
Possible cause
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Unsuitable cookware.
No cookware on the cooking
zone.
The diameter of the bottom
of the cookware is too small
for the cooking zone.
Electronics fault.
Overheating protection for
the cooking zone operates.
Remedy
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
Use suitable cookware.
Place cookware on the cook-
ing zone.
Move onto a smaller cooking
zone.
Disconnect the appliance
from the electrical supply for
a few minutes. Take the fuse
out of the house's electric
system. If after switching on
again,
is displayed
again, call the After Sales
Service.
Switch off the appliance. Re-
move the hot cookware. Af-
ter approximately 30 sec-
onds switch on the cooking
zone again.
should dis-
appear, residual heat indi-
cator can stay. Cool down
the cookware and check it
with the section "Cookware
for the induction cooking
zones".
14