Kohler KD 500 Посібник для семінару - Сторінка 35

Переглянути онлайн або завантажити pdf Посібник для семінару для Двигун Kohler KD 500. Kohler KD 500 44 сторінки. 51267

Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00

Counter-shaft float (optional):

Place a calibrated bar on a level with the timing system cover

retention surface and use a thickness gauge to check the

distance between the stop surface and bar (fig. 64). The

measured value must be between:

0,10 ÷ 0,25 mm

Spread liquid seal of the AREXON D 0036 MOTORSIL type on

the retention surface of the timing system cover (fig.65).

Place the cover on the casing.

Insert the cover fixing screws, making sure that the five shorter

ones (40 mm) are mounted in the top part of the cover. Tighten

to the following torque value:

2,7 ÷ 2,8 kgm (26,5 ÷ 27,5 Nm)

1. Immerse the retention ring in oil for about 10 minutes.

2. Clean the housing and insert the ring with a plug, exercising

an even pressure all over the surface (fig.66).

Block the flywheel (fig. 67) and torque the nut to value:

18 ÷ 20 kgm (176,5 ÷ 196,1 Nm)

Engine assembly

- 35 -