Aquarii Zino Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з монтажу для Прожектор Aquarii Zino. Aquarii Zino 11 сторінок. Slope recessed
COMMUNICATION CONNECTIONS
Secure DMX/RDM Connection
See the DMX Wiring for a Zino LED Fixture in the diagram below:
Follow the steps below to secure the DMX/RDM Connections to the fixture.
1. Determine the present Communication Board, then secure the DMX Communication Wiring to the board based on the
local sites wiring options. The four possible options are:
• XLR - 5 Pin (P/N: 17-00005)
• RJ-45 (P/N: 17-00004)
• Insulation Displacement Connector (IDC) (P/N: 17-00003)
• Screw Terminal (P/N: 17-00002)
2. Ensure the DMX Wire Harness connection from the Controller to Communication Board has not been disrupted.
3. Set the fixtures DMX Address as needed.
NOTE:
All DMX Wiring should be compatible with Telecommunications Industry Association TIA/EIA-485 (RS-485). See the table on
Page 7 of this manual for the required DMX over CAT5e/6 Information.
6