Aquarii Zino Kurulum Kılavuzu - Sayfa 8

Taşkın Işık Aquarii Zino için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Aquarii Zino 11 sayfaları. Slope recessed

COMMUNICATION CONNECTIONS

See the DMX Wiring for a Zino LED Fixture in the diagram below:

Follow the steps below to secure the DMX/RDM Connections to the fixture.

1. Determine the present Communication Board, then secure the DMX Communication Wiring to the board based on the

local sites wiring options. The four possible options are:

• XLR - 5 Pin (P/N: 17-00005)

• RJ-45 (P/N: 17-00004)

• Insulation Displacement Connector (IDC) (P/N: 17-00003)

• Screw Terminal (P/N: 17-00002)

2. Ensure the DMX Wire Harness connection from the Controller to Communication Board has not been disrupted.

3. Set the fixtures DMX Address as needed.

NOTE:

All DMX Wiring should be compatible with Telecommunications Industry Association TIA/EIA-485 (RS-485). See the table on

Page 7 of this manual for the required DMX over CAT5e/6 Information.