Olympus IX71 Посібник з монтажу - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мікроскоп Olympus IX71. Olympus IX71 11 сторінок. Microscope z-axis motor drive
Також для Olympus IX71: Брошура та технічні характеристики (16 сторінок)

Друкувати сторінку

Last update: 2021/09/23 17:15

Tighten the baseplate clamp snugly.

Tighten the ﬂexible coupler's clamp onto the drive shaft.

Tighten the clamp of the ﬂexible coupler onto the drive shaft of the Z-drive unit using the 5/64

inch Allen wrench.

Note: The ﬂexible coupler clamp must be securely tightened or the drive may slip.

Lightly tighten the vertical and horizontal adjustment screws as shown. Since the motor is

usually self-aligning, this should be a good position for the drive. Check the alignment by noting

the drag while rotating the right-hand ﬁne focus knob. No noticeable drag should be felt for the

full 360º rotation of the ﬁne focus knob. If any drag is felt other than the slight drag of the

gears, loosen the vertical and horizontal adjustment screws and move the drive to a point

where no drag is felt. Then tighten the vertical and horizontal adjustment screws.

Tighten the vertical adjustment screws after alignment.

https://asiimaging.com/docs/

olympus_ix71_zdrive_install https://asiimaging.com/docs/olympus_ix71_zdrive_install

Printed on 2022/01/10 05:45