Olympus IX71 Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мікроскоп Olympus IX71. Olympus IX71 11 сторінок. Microscope z-axis motor drive
Також для Olympus IX71: Брошура та технічні характеристики (16 сторінок)

Друкувати сторінку

2022/01/10 05:45

Slide the drive shaft into the ﬂexible coupler.

Coupler accepts about 4 mm of the drive shaft.

Reinstall the horizontal adjustment screw and tighten loosely for later adjustment.

Rotate the adjustment bar so that the lip on the bottom of the adjustment bar mates with the

groove in the baseplate. Align the holes on the adjustment bar to those on the drive and the

baseplate, and screw in the horizontal adjustment screw to hold the drive assembly in place

using the 7/64 inch Allen wrench. Leave the adjustment screws loose enough so that later the

drive can slide up and down and the adjustment bar can slide back and forth within the

baseplate.

After verifying the baseplate and motor drive is appropriately positioned under the microscope,

snugly tighten the baseplate clamp on the right side of the microscope. Use the 5/64 inch Allen

wrench to tighten the setscrew located in the middle of the clamp assembly as shown.

Tightening this setscrew will cause the silver bar to press against the side of the microscope.

Ensure that the setscrew is securely tightened to hold the baseplate assembly in place.

Applied Scientiﬁc Instrumentation - https://asiimaging.com/docs/

7/11

Olympus IX71 Microscope Z-Axis Motor Drive Installation