Olympus IX71 설치 매뉴얼 - 페이지 7

{카테고리_이름} Olympus IX71에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Olympus IX71 11 페이지. Microscope z-axis motor drive
Olympus IX71에 대해서도 마찬가지입니다: 브로셔 및 사양 (16 페이지)

페이지 인쇄

2022/01/10 05:45

Slide the drive shaft into the ﬂexible coupler.

Coupler accepts about 4 mm of the drive shaft.

Reinstall the horizontal adjustment screw and tighten loosely for later adjustment.

Rotate the adjustment bar so that the lip on the bottom of the adjustment bar mates with the

groove in the baseplate. Align the holes on the adjustment bar to those on the drive and the

baseplate, and screw in the horizontal adjustment screw to hold the drive assembly in place

using the 7/64 inch Allen wrench. Leave the adjustment screws loose enough so that later the

drive can slide up and down and the adjustment bar can slide back and forth within the

baseplate.

After verifying the baseplate and motor drive is appropriately positioned under the microscope,

snugly tighten the baseplate clamp on the right side of the microscope. Use the 5/64 inch Allen

wrench to tighten the setscrew located in the middle of the clamp assembly as shown.

Tightening this setscrew will cause the silver bar to press against the side of the microscope.

Ensure that the setscrew is securely tightened to hold the baseplate assembly in place.

Applied Scientiﬁc Instrumentation - https://asiimaging.com/docs/

7/11

Olympus IX71 Microscope Z-Axis Motor Drive Installation