Digiflex RF159 Посібник інсталятора - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник інсталятора для Контролер Digiflex RF159. Digiflex RF159 8 сторінок. 2 channel smart rf controller - 433mhz

Друкувати сторінку

Receiver Operation

The RF159 will turn on the green RX LED to indicate the unit is powered and it will blink off each time a signal is re-

ceived. Each time a keyfob button is pressed the corresponding relay will operate and a confirmation signal is sent to

the keyfob to indicate a successful 2 way transaction. When button RLY1 or RLY2 are triggered manually they operate

the corresponding relay to allow you to test your connections and device your operating.

WARNING always be sure to check that there is no objects in the way when operating an automatic device as this

could cause damage or injury to a person.

Relay Programming

RLY1 and RLY2 can be individually programmed to operate in pulse or toggle mode by selecting the corresponding

mode number. Pulse mode is available in different timings from 1 second to 120 seconds to allow easy interface to

automatic gates and doors . Toggle mode will operate the relay when the keyfob button is pressed and will release

the relay on the next keyfob button press.

Action

Enter Relay

Programing Mode

Selecting The Relay

RLY1 LED will flash the number of times corresponding to the currently programmed setting.

Set Relay Mode

RLY1 LED will flash the number of times corresponding to the currently programmed setting, pause then repeat.

1=1s, 2=2s, 3=3s, 4=4s, 5=5s, 6=10s, 7=20s, 8=60s, 9=120s, 10=toggle

Program Other

Relay

RLY1 LED will flash the number of times corresponding to the currently programmed setting, pause then repeat.

1=1s, 2=2s, 3=3s, 4=4s, 5=5s, 6=10s, 7=20s, 8=60s, 9=120s, 10=toggle

Exit Programming

Mode

Steps

Press RLY1 and RLY2 For 4

seconds

Press Relay Button To

Select (E.g. RLY1)

Press Relay Button To

Change Mode (E.g. RLY1)

Each time you press RLY1 it will increment to the next mode as follows.

Press Relay Button To

Select (E.g. RLY2)

Each time you press RLY1 it will increment to the next mode as follows.

Press RLY1 and RLY2 for 1

seconds or timeout

after 60 seconds

LED Legend

Table 1: RF159 Relay Programming

E&OE

Program Relay Functions

LED's

RF: ON

PGM: ON

RLY1: ON

RLY2: ON

RF: ON

PGM: ON

RLY1: Pulse current mode

RLY2: OFF

RF: ON

PGM: ON

RLY1: Pulse current mode

RLY2: OFF

RF: ON

PGM: ON

RLY1: OFF

RLY2: Pulse current mode

RF: On

PGM: OFF

RLY1: OFF

RLY2: OFF

Fast Flash

Slow Flash

Steady On

Steady

Red

Green

Comment

RLY1

PGM

RLY1

PGM

RLY1

PGM

RLY1

PGM

RLY1

PGM

OFF

P/N: RF159IRG Rev 1.3

RLY2

Page

