Cisco ASR 920 series Посібник з встановлення - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з встановлення для Перемикач Cisco ASR 920 series. Cisco ASR 920 series 42 сторінки. Aggregation services router
Також для Cisco ASR 920 series: Посібник з встановлення (36 сторінок), Початок роботи (6 сторінок), Посібник з встановлення обладнання (46 сторінок), Посібник (36 сторінок)

Installing the Cisco ASR 920 Series Router

Installing the Router Chassis in the Rack

Note

Ensure adequate air flow when mounting the router in a rack. For more information, see the "Air Flow

Guidelines" section on page 11 .

Note

Install the cable guides before installing the router in a 19-inch EIA rack. See

To install the router chassis in the equipment rack, perform these steps:

SUMMARY STEPS

1. Position the chassis in the rack as follows:

2. Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the equipment

rack.

3. Install the four M6x12mm zinc-plated steel screws through the holes in the bracket and into the threaded

holes in the equipment rack posts.

4. Use a tape measure and level to verify that the chassis is installed straight and level.

DETAILED STEPS

Step 1

Position the chassis in the rack as follows:

• If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between the mounting

posts.

• If the rear of the chassis is at the front of the rack, insert the front of the chassis between the mounting posts.

Step 2

Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the equipment rack.

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Installing the Router Chassis in the Rack

Attaching the Cable

Guides.