Cisco MERAKI MR66 Посібник з монтажу - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з монтажу для Шлюз Cisco MERAKI MR66. Cisco MERAKI MR66 20 сторінок. Troubleshooting mesh communication between access points
Також для Cisco MERAKI MR66: Посібник (7 сторінок)
Друкувати сторінку
- 1. Package Contents
- 2. Understanding the MR66
- 3. Antennas and Ports
- 4. Pre-Install Preparation
- 5. Power Source Options
- 6. Factory Reset Button
- 7. Led Indicators and Run Dark Mode
- 8. Check and Upgrade Firmware
- 9. Collect Tools
- 10. Collect Additional Hardware for Installation
- 11. Installation Instructions
- 12. Choose Your Mounting Location
- 13. Verify Device Functionality and Test Network Coverage
- 14. Troubleshooting
- 15. Regulatory Information for MR66
Powering the MR66 with an 802.3af Power over Ethernet Switch
Route Ethernet cable from a port on an active 802.3af PoE switch to the Eth0 port in the bay of the MR66. The MR66 is
Gigabit Ethernet-capable. To maximize device performance, a Gigabit-capable switch should be used.
Attach Power over Ethernet to the MR66
1. Remove the dust cover from the Ethernet port of the MR66. Unscrew it with a coin or flathead screwdriver.
2. Route the Ethernet cable from the PoE Injector "OUT" port to the MR66.
3. Install a Cable Gland on the MR66 end of the cable.
13