DirecTV Genie C41W Посібник з встановлення та усунення несправностей - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з встановлення та усунення несправностей для Приймач DirecTV Genie C41W. DirecTV Genie C41W 16 сторінок. Directv wireless video bridge and wireless genie mini
Друкувати сторінку
Wireless Video Bridge Setup/Beacon Mode
1. Select the placement for the WVB. Select a location for the WVB
based on the following factors:
Best location to provide signal to all C41Ws and potential
∎
locations the customer may move a C41W client to.
Access to the coax SWiM network
∎
2. Power on the WVB and observe the power up sequence. The WVB
will boot up to Beacon Mode.
WVB LED flashes
∎
The boot up takes approximately one to two minutes.
∎
Once boot up has completed, the WVB LED alternates green/
∎
yellow.
The WVB is now in Beacon Mode.
∎
∎
Beacon Mode works only on WVB and clients that have not
previously been paired (factory fresh) or client that have
been reset to factory defaults.
3. Setup the wireless clients (C41W) in the location they will be used.
If the C41W is to be mounted behind the TV, it should be
∎
placed as close to its final mounted position as possible to
fully verify signal quality to the WVB.
Make sure you remove the plastic film from the C41W;
∎
4. Connect the C41W to the TV and power on. The C41W will boot
up to the Connecting to Video Bridge screen. Proceed to the
next step in the installation, but
Continue, depending on your software version; older software
versions will state Continue) at this
to verify signal.
5. The signal strength on every C41W should be checked by ensuring
that the LED and on-screen signal meter is green.
The LED on the front of the C41W has roughly a ten-second
∎
refresh rate, so when moving the C41W, wait about ten
seconds and verify the color of the LED.
Wireless Genie Mini and WVB
during boot up.
blue
do not select Connect Now (or
time. Move to the next client
If one or more of the C41Ws' network LED are not green,
∎
the WVB will need to be relocated to an area that maximizes
signal range to all clients and minimizes interference. If more
than one C41W will be installed and a
be achieved on all C41Ws the technician has the following
options:
Use a wired client (C31/C41). Follow existing guidelines to
∎
install the wired client if needed.
Use more than one WVB. Choose another location for the
∎
first WVB that covers most of the C41W clients and choose
a location for a second WVB to cover the C41W client(s)
that have poor signal coverage.
6. Do not proceed if the signal strength is fair
A
yellow
LED on the C41W indicates poor signal strength to the
WVB. Consider moving the WVB, adding another WVB, or using a
wired client.
If a technician is finding it very difficult to get
coverage on all C41Ws in a single household after trying multiple
locations in Beacon Mode, they can add a second Wireless Video
Bridge to the work order without calling TSC. However, in most pilot
households, we found that a single Wireless Video Bridge can support
the entire network of C41Ws and a second Wireless Video Bridge was
not necessary. In 98.5% of all installations during the pilot, only one
WVB was needed.
Try to focus on good WVB placement; this will help all the clients get a
good signal, and can prevent future service calls.
Installation
WVB and C41W Installation
green
LED cannot
(yellow
network LED's).
LED signal
green
2