DirecTV Genie C41W Посібник з встановлення та усунення несправностей - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з встановлення та усунення несправностей для Приймач DirecTV Genie C41W. DirecTV Genie C41W 16 сторінок. Directv wireless video bridge and wireless genie mini
Друкувати сторінку
WVB Installation
1. If not previously performed, install the ODU/SWiM and run the coax cable to the WVB location(s).
2. If not previously performed, install, update the software, and activate the Genie Server.
3. Connect the WVB to the SWiM/MoCA network (if more than one WVB is used, connect all WVBs to the SWiM/MoCA network)
4. If the WVB is not powered on, power on the WVB. After a short delay (one to two minutes) the LED should be solid green. Note:
The LED will be solid
or solid
green
blue,
5. On the Genie Server, verify the OSD "A wireless video bridge has been found and configured successfully" has been displayed.
Select OK to clear the OSD. This often takes only 30 seconds, however it can take up to five minutes in some cases.
If the OSD does not display on the Genie Server, check the WVB LED and refer to the troubleshooting section.
∎
6. Verify all WVBs are connected to the Genie Server by checking the WVB status under Whole Home - Video Bridge - Video Bridge
Status on the Genie Server.
Each WVB in the system should show ACTIVE.
∎
7. Installation of the WVB is complete once all WVBs appear ACTIVE on the Genie Server's Video Bridge Status screen, and all WVBs
have a solid
or solid
green
have a wired or wireless client connected).
The installation preference of the WVB is as follows:
Home run wiring from the SWiM splitter to both
∎
the WVB and HR44.
Home run wiring from the SWiM splitter to the
∎
WVB; then a coax jumper from the WVB to the
HR44.
A split cable run to the WVB is not
∎
recommended.
Wireless Genie Mini and WVB
if the Genie Server previously had ANY clients (wired or wireless) paired to it. If the LED is not solid
blue
refer to Troubleshooting section. (Full boot takes one to two minutes, so be patient.)
LED. (This means that the Genie Server and the WVB are connected, even though you may not
blue
Installation
WVB and C41W Installation
3