3D Hobby Shop Velox VR-1 Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для Іграшка 3D Hobby Shop Velox VR-1. 3D Hobby Shop Velox VR-1 17 сторінок.

Using a 2mm Phillips screw, washer, and nut, attach the ball joint to the rudder horn. Do this on both

sides of the rudder. Use a drop of thick CA glue, as shown in the pull-pull diagram, to lock the 2mm nut

Assemble the dual-sided rudder servo arm with two servo adjustors as shown. Please refer to the pull-

pull system diagram as needed and note that these adjustors must be free to rotate after installation, so

the nuts which retain them should be tightened only until almost snug and then glued with a small drop of

thick CA to lock the nut so that it will not fall off. Note – in these photos, the optional 3DHobbyShop long

arm set is shown. You can use a variety of different servo arms, some transmitters will require the use of

long servo arms to achieve full 3D throw. If you are unsure of the arm length required, we recommend

not gluing the adjustor nuts until you have set your control throws.

on the bottom of the rudder control horns after tightening.

Install the rudder servo into the fuselage as shown