3D Upfitters LulzBot Mini 2 R1 Посібник з монтажу - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3D Upfitters LulzBot Mini 2 R1. 3D Upfitters LulzBot Mini 2 R1 18 сторінок. Enclosure kit

Друкувати сторінку

attaching to the ﬁlter and back of the enclosure using M4 cap head 30mm or 40mm screws

depending on the depth of the particular fan.

The air ﬁlter should look like this after being attached.

Note that its easier to insert the screws from the

inside, and put the nuts next to the ﬁlter housing.

If you didn't purchase an air ﬁlter you should just

see a fan, as shown to the right. As with the ﬁlter,

make sure the fan is blowing air out of the

enclosure.

7. Attach Top

First move the partially assembled enclosure, the Front, Left Side, and Back, and place

them around the LulzBot Mini 2 as pictured below.