Alto Triton 850 Інструкція з експлуатації Посібник з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Мийка високого тиску Alto Triton 850. Alto Triton 850 16 сторінок.
Також для Alto Triton 850: Інструкція з експлуатації Посібник з експлуатації (16 сторінок)
Друкувати сторінку
4.0 Cleaning with a high pressure washer
4.1 General Information
Efficient high pressure cleaning is achieved by
following a few guidelines, combined with your
own personal experience of specific cleaning
tasks. Accessories and detergents, when cor-
rectly chosen, can increase the efficiency of
your pressure washer. Here is some basic in-
formation about cleaning.
Soaking Incrusted or thick layers of dirt
can be loosened or softened up by a pe-
riod of soaking. This is for example an
ideal method within agriculture – for exam-
ple, within pig sties. The ideal soaking
method can be achieved via use of foam or
simple alcaline detergent. Let the product
lie on the dirty surfaces for around 30 min-
utes before pressure washing. The result
will be a much quicker high pressure clean-
ing process.
Detergent and Foam Application Foam
or detergent should be applied onto dry
surfaces so that the chemical product is in
direct contact with the dirt. Detergents are
applied from bottom to top, for example on
a car bodywork, in order to avoid "super
4.2 Some typical cleaning tasks
Agriculture
Task
Accessories
Stables
Chemical Foam
Pig Pens,
Injectors
Foam lance.
Sties
Powerspeed lance.
Floor Cleaner
Cleaning of
Powerscraper/
walls, floors
Powerlift lance
and equip-
ment.
Detergents
Universal
Disinfection
Alkafoam
Disinfectant
DES 3000
1. Soaking – apply
16
clean" areas, where the detergent collects
in higher concentration and streams down-
wards. Let the detergent react several
minutes before cleaning off.
Temperature Detergents are more effec-
tive at higher temperatures. Greases, oils
and fats can be broken down more easily
at higher temperatures also. Proteins can
be cleaning at temperatures of around
60°C. Oils, pollution and grease can be
cleaning between 70° and 90° C.
Mechanical Effect In order to break down
tough layers of dirt, additional mechanical
effect may be required. Special lances and
rotary or wash brushes offer this supple-
mentary effect that cuts through dirt. Use a
brush to cut through e.g. traffic film.
High Water Flow or High Pressure High
pressure is not always the best solution
and high pressure may damage surfaces.
The cleaning effect also depends upon
water flow. Pressure levels of around 100
bar may be sufficient for vehicle cleaning
(in association with hot water). Higher flow
levels give the possibility to rinse and flush
away large amounts of dirt easily.
Method
foam to all surfaces (bottom to top) and wait for approx
30 minutes.
2. Remove the dirt from surfaces with the high pressure
lance or chosen accessory. Again, clean from bottom to
top on vertical surfaces.
3. To flush away large quantities of dirt, change to low pres-
sure mode and use the higher flow to push away the dirt.
4. Use recommended disinfectant products and methods to
ensure hygiene. Only apply disinfectants once the dirt
has been fully removed.
GB
Continued