3Doodler 2.0 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари 3Doodler 2.0. 3Doodler 2.0 10 сторінок.
Також для 3Doodler 2.0: Посібник із швидкого старту (2 сторінок), Посібник (4 сторінок)

Друкувати сторінку

1. Troubleshooting and Cleaning the Pen

3Doodler is set to continuous flow,

firmly press down on the Maintenance

Cover

to slightly speed up the

extrusion of your plastic/filament.

NOTE: Our 3Doodler is a

sturdy and awesome tool, but

like any mechanical device it

needs a break now and then.

We suggest giving it (and

yourself) some downtime after

2 hours of continuous use (just

a 30 minute break or so).

TROUBLESHOOTING AND CLEANING THE PEN

If the extrusion of plastic/filament has slowed down, stopped, or if

you are having trouble inserting plastic into the pen, please give the

plastic/filament a gentle clockwise twist while pushing it down the

shaft of the 3Doodler.

If the nozzle is loose, please gently tighten it, stopping when you

first feel resistance, and being sure to do so while the pen is hot.

Try to extrude again.WARNING: DO NOT force the nozzle or

overtighten it, as you could irreparably damage your 3Doodler.

If this does not work, we suggest cleaning the 3Doodler. Please

follow the steps below:

1. Ensure the LED light is BLUE or GREEN before starting

this process (indicating that the pen is hot).

2. Start by using the nozzle removal tool

and unscrew the nozzle anti-clockwise

while the pen is hot. Please be careful not

to touch the nozzle!

3. Once you have removed the nozzle,

hold down either the FAST (3) and SLOW

(4) speed buttons. While holding down

either button, insert the Cleaning Tool

through the back of the pen and gently

push any any excess plastic/filament out

of the front of the pen. In order to feed the Cleaning Tool past the

gear system you will need to gently twist it counter clockwise until

you feel it move past the gears.

clockwise twist

Turn nozzle

removal tool

anti-clockwise