Dodge Tigear-2 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Промислове обладнання Dodge Tigear-2. Dodge Tigear-2 8 сторінок. Accessory kit
Також для Dodge Tigear-2: Інструкція з експлуатації (2 сторінок)
Друкувати сторінку
RISER BLOCK KIT
Place the riser blocks between the reducer and the bolt-on base.
The riser blocks may be supplied either as two pieces with two
holes each or as one piece with four holes. If the two piece style
riser block has offset holes, place the riser block on the reducer
to minimize the amount the riser block hangs off the ends of the
reducer (install riser blocks as shown in View A, not View B).
Install the screws supplied in the kit and tighten all screws to two-
thirds of the appropriate value listed. Tighten all screws to the
final torque given.
WARNING: If washers are supplied, it is extremely important to use
them with the screws when attaching the base. The supplied screws
MUST be tightened to the torque values listed below. The torque
values listed are based upon the use of the supplied fasteners
which are pre-coated with a thread locker that can only be used
once. If a screw is removed during initial installation, the screw must
be discarded and replaced with a new pre-coated screw. Failure
to follow the above procedure may result in serious injury or death
from falling items.
VIEW A
Reducer Size
Bolt or Screw Size
13
15
17
20
23
26
30
35
40
47
HEX HEAD CAP SCREWS WITH
FLAT WASHERS
(QTY.4)
BOLT-ON BASE (NOT PART
OF KIT)
RISER BLOCKS (SEE TEXT
FOR QTY.)
NOTE: FLAT WASHERS TO BE
USED WITH ALL TIGEAR-2
SIZES EXCEPT SIZE 40.
VIEW B
Tightening Torque
(ft-lb)
1/4-20
8
1/4-20
8
5/16-18
17
3/8-16
30
3/8-16
30
3/8-16
30
7/16-14
48
7/16-14
48
5/8-11
130
5/8-11
130
OUTPUT FLANGE KIT
INSTALLATION ON BEARING COVER SIDE: Remove and
discard the four retaining screws on the outside corners of the
bearing cover. Do not remove the two smaller screws. Install
the output flange over the bearing cover. Install the supplied
longer screws, flat washers, and lock washers and tighten
all screws to two-thirds of the appropriate value listed below.
Tighten all screws to the final torque value given.
INSTALLATION ON SIDE WITHOUT BEARING COVER:
Install the output flange and the supplied shorter screws, flat
washers, and lock washers. Tighten the screws to the tightening
torque values listed in the table below.
OUTPUT FLANGE
(QTY. 1)
SOCKET HEAD CAP SCREW
(QTY. 4)
Reducer
Bolt or Screw Size
Size
17
20
23
26
30
35
2
FLAT WASHER
(QTY. 4)
LOCK WASHER
(QTY. 4)
Tightening
Torque
(ft-lb)
5/16-18
17
5/16-18
17
3/8-16
30
3/8-16
30
7/16-14
48
7/16-14
48
MN1661