Dodge Tigear-2 Інструкція з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Промислове обладнання Dodge Tigear-2. Dodge Tigear-2 8 сторінок. Accessory kit
Також для Dodge Tigear-2: Інструкція з експлуатації (2 сторінок)
Друкувати сторінку
OUTPUT BRACKET KIT
Attach the output bracket to the reducer bottom using the
supplied screws and lock washers. If a spacer is supplied, install
the spacer between the reducer top and output bracket and use
the longer two bolts supplied. Install the supplied screws and lock
washers. Tighten all screws to the tightening torque values listed
in the table below.
Reducer
Bolt or Screw Size
Size
13
15
17
20
23
26
30
35
Tightening
Torque
(ft-lb)
1/4-20
8
1/4-20
8
5/16-18
17
3/8-16
30
3/8-16
30
3/8-16
30
7/16-14
48
7/16-14
48
OUTPUT SAFETY COVERS
INSTALLATION ON BEARING COVER SIDE (applies to
hollow shaft units only): Remove and discard the four retaining
screws and lock washers on the outside corners of the bearing
cover. Do not remove the two smaller screws. Using the longer
screws supplied in the kit, install the safety cover with the lock
washers sandwiched between two larger flat washers on each
outside corner of the bearing cover as depicted in the diagram
below. Be certain to orient the drain port in a downward position
if possible. Torque the screws to the values listed in the table
below.
INSTALLATION ON SIDE WITHOUT BEARING COVER
(applies to hollow shaft units only): Using the shorter screws
supplied in the kit, install the safety cover with the lock washers
sandwiched between two larger flat washers on each outside
corner of the bearing cover as depicted in the diagram below. Be
certain to orient the drain port in a downward position if possible.
Torque the screws to the values listed in the table below.
NOTE: The lock washers will fit inside the holes at the four corners
of the safety cover.
WIDE FLAT WASHERS
(QTY. 8)
Reducer
Bolt or Screw Size
Size
17
20
23
26
30
35
40
3
LOCK
WASHERS
(QTY. 4)
HEX HEAD
CAP SCREWS
SAFETY
(QTY. 4)
COVER
(QTY. 1)
Tightening
Torque
(ft-lb)
5/16-18
17
5/16-18
17
3/8-16
30
3/8-16
30
7/16-14
48
7/16-14
48
5/8-11
130
MN1661