Cypress MB96300 Series Посібник з налаштування - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник з налаштування для Мікроконтролери Cypress MB96300 Series. Cypress MB96300 Series 11 сторінок. F2mc-16fx family
Друкувати сторінку3.2 Jumper settings on the adapter board
Jumper pins are provided on the adapter board and must be set according to the operating conditions. The figure below
shows the location for the jumper pins that need to be set. Each jumper pin setting is described in Table 3-1 to Table 3-4.
The recommended jumper pin settings are shown highlighted in gray (■). Set the jumper pins on the adapter board
according to the descriptions in the tables.
AVSS_OUT
=USR side
AVRH_OUT
=USR side
AVRL_OUT
=USR side
AVRL_IN
= A-B side
DVDD
=USR side
RTSX
=USR side
*2 If a sub clock is to be used, set the jumper on the adapter board to the CLK side, then connect the sub clock to the IC
socket for the crystal oscillator.
2
F
MC-16FX Family MB96300 Series Setup Guide, Doc. No. 002-06378 Rev. *A
Figure 3-2. Jumper Pin Locations on the Adapter Board
AVCC_OUT
=USR side
AVRH_IN
= A-B side
AVCC_IN
=A-B side
Hardware Setup
X0A, X1A
=EML side
X0, X1
=EML side
Oscillator clock *1
(crystal oscillator)
*1 User must supply a
crystal oscillator rated
for the frequency used
in the user system.
CLKSEL0, CLKSEL1
=PORT side *2
C =EML side
MD0_SEL, MD1_SEL,
MD2_SEL=L side
MD0, MD1, MD2
= USR side
8