Cypress MB96300 Series Посібник з налаштування - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з налаштування для Мікроконтролери Cypress MB96300 Series. Cypress MB96300 Series 11 сторінок. F2mc-16fx family

Друкувати сторінку
Table 3-1. Jumper Settings on the Adapter Board (Debug power supply selection)
Jumper
Setting
DVDD
DBG side
USR side (default)
RSTX
DBG side
USR side (default)
MD2,MD1,
DBG side
MD0
USR side (default)
MD2_SEL,
H side
MD1_SEL
MD0_SEL
L side (default)
Table 3-2. Jumper Settings on the Adapter Board (Short plug settings for clock changeover)
Jumper
Setting
X1,
USR side
X0
EML side (default)
X1A,
USR side
X0A
EML side (default)
CLKSEL1,
PORT side (default)
CLKSEL0*
CLK side
* If a sub clock is to be used, set the jumper on the adapter board to the CLK side, and then connect the sub clock to the
IC socket for the crystal oscillator.
2
F
MC-16FX Family MB96300 Series Setup Guide, Doc. No. 002-06378 Rev. *A
Supply DC regulated power supply from connection at UVCC connector (CN7).
Supply DVCC power supply from the user system.
Fix RSTX to "H" using DC regulated power supply from connection at UVCC connector
(CN7).
Supply the RTSX signal from the user system.
Supply the mode pin signal on the adapter board.
Supply the mode pin signal from the user system.
These jumpers set the mode pins for the evaluation MCU. These settings are enabled when
the MD2-MD0 jumpers are set to the DBG side.
Each signal level is set to the output level of the DC regulated power supply connect to the
UVCC connector (CN7).
Supply the main clock from the user system
Supply the main clock from the crystal oscillator IC socket on the adapter board
Supply the sub clock from the user system
Supply the sub clock from the crystal oscillator IC socket on the adapter board
Use the port/sub clock input pin (P040/X0A, P041/X1A) as a port
Use the port/sub clock input pin (P040/X0A, P041/X1A) as the sub clock input pin
Description
Description
Hardware Setup
9