Diamond TQ-1800 Installations- und Betriebshandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Kommerzielle Lebensmittelausrüstung Diamond TQ-1800 herunter. Diamond TQ-1800 20 Seiten. Electric conveyor toasters

Seite drucken

INSTALLATION

FRONT OR REAR DISCHARGE

Toast-Qwik

units can be set up so toasted product

discharges at either the front or the rear of the unit.

WARNING

To assure safe and proper operation while

operating in the Front Discharge mode, allow a

minimum clearance of 1" (25 mm) along the

sides and rear. Allow a minimum clearance of

12" (305 mm) along the front.

WARNING

To assure safe and proper operation while

operating in the Rear Discharge mode, allow a

minimum clearance of 1" (25 mm) along the

sides. Allow a minimum clearance of 12"

(305 mm) along the front and rear.

TQ-10 & TQ-15 MODELS ONLY

The TQ-10 & TQ-15 models use a one piece

discharge chute/collector pan. The installation

location determines discharge area.

For front discharge install toaster chute from the

front of the toaster with the curved end inward and

the rear lip of the chute on the rear most pins. See

Figure 8.

For rear discharge install toaster chute from the

rear of the toaster with the curved end in, and the lip

of the chute over the inside set of pins. See

Figure 9.

TQ-400, -800, -1200 & -1800 SERIES

TQ-400, -800, -1200 and -1800 series toasters use

a separate discharge chute and collector pan.

For front discharge install the chute first by placing

the curved end inward until the rear lip of the chute

is on the upper most set of pins and the front slots

on the chute are on the inside set of pins. Position

the collector pan, with the open end in first, over the

remaining sets of pins. Align slanted notches over

the pins and lower into place. See Figure 10.

For rear discharge the TQ-400, -800, -1200 and

-1800 series toasters do not use the discharge

chute. If the chute is installed remove it. To set-up

toaster for rear discharge position, install the

collector pan, with the open end first, over the set of

pins at the rear of the unit. Align the straight notches

over the pins and lower into place. See Figure 11.

Form No. TQ2M-1005

Figure 8. TQ-10 & TQ-15 Front Discharge

Figure 9. TQ-10 & TQ-15 Rear Discharge

Collector Pan

Figure 10. TQ-400, -800, -1200 & -1800 Series

Front Discharge

Figure 11. TQ-400, -800, -1200 & -1800 Series

Rear Discharge

Discharge

Chute